GAS EC ACTIVE MALE TO MALE CABLE 5M

Description

The GAS EC cable network uses active cabling to carry both data and power between controllers, speed controllers, and other GAS-compatible devices. This 5-metre male-to-male active cable extends the distance between nodes in a GAS installation — for example, where a controller is ceiling-mounted at the far end of a larger grow space and standard-length cables don’t reach cleanly.

Active cables in the GAS system are directional — the male-to-male configuration extends a run between two female-terminated connection points. Check your existing GAS cable layout before ordering to confirm you need the male-to-male format rather than a different GAS cable variant. Maintain neat cable routing to reduce the risk of mechanical damage to the connectors over time.

Planning cable runs before installation saves reworking a GAS system later. Map out where each controller, sensor and peripheral device needs to sit within the growing space, then work out the cable lengths needed between each connection point — a 5-metre active cable bridges most gaps in a single tent or small grow room setup, but larger installations with controllers and devices spread across multiple rooms may need to combine several cable lengths or plan device positioning around available cable runs. Because these are active cables carrying data as well as power, avoid running them in tight bundles alongside high-current mains cabling over long parallel runs, which can introduce interference even on a well-shielded cable. Label each cable at both ends during installation, particularly in larger GAS networks with multiple devices and similar-looking cable runs — this makes future troubleshooting or reconfiguration considerably faster than tracing an unlabelled cable back through a fully built-out system.

Keep spare cables on hand once your GAS network is fully built out — replacing a single suspect cable is a faster first troubleshooting step than working through the whole installation looking for a fault, and having a known-good spare on the shelf turns a potential system-down situation into a five-minute swap.

At a glance:

• 5-metre active male-to-male GAS EC cable
• Extends distance between GAS network devices
• Carries both data and power
• One per installation, correctly oriented male-to-male